Jasmonates (JAs) are a family of oxylipin phytohormones regulating plant development and growth and mediating ‘defense versus growth’ responses. The upstream JA biosynthetic precursor cis-(+)-12-oxo-phytodienoic acid (cis-OPDA) acts independently of CORONATIVE INSENSITIVE 1 (COI1)-mediated JA signaling in several stress-induced and developmental processes. However, its perception and metabolism are only partially understood. A few years ago, a low abundant isoleucine analog of the biologically active JA-Ile, OPDA-Ile, was detected years ago in wounded leaves of flowering plants, opening up the possibility that conjugation of cis-OPDA to amino acids might be a relevant mechanism for cis-OPDA regulation. Here, we extended the analysis of amino acid conjugates of cis-OPDA and identified naturally occurring OPDA-Val, OPDA-Phe, OPDA-Ala, OPDA-Glu, and OPDA-Asp accumulating in response to biotic and abiotic stress in Arabidopsis (Arabidopsis thaliana). The OPDA-amino acid conjugates displayed cis-OPDA-related plant responses in a JA-Ile-dependent manner. We also showed that the synthesis and hydrolysis of cis-OPDA amino acid conjugates are mediated by members of the amidosynthetase GRETCHEN HAGEN 3 (GH3) and the amidohydrolase INDOLE-3-ACETYL-LEUCINE RESISTANT 1 (ILR1)/ILR1-like (ILL) families. Thus, OPDA amino acid conjugates function in the catabolism or temporary storage of cis-OPDA in stress responses instead of acting as chemical signals per se.

SUMMARYWHIRLY1 belongs to a family of plant‐specific transcription factors capable of binding DNA or RNA in all three plant cell compartments that contain genetic materials. In Arabidopsis thaliana, WHIRLY1 has been studied at the later stages of plant development, including flowering and leaf senescence, as well as in biotic and abiotic stress responses. In this study, WHIRLY1 knockout mutants of A. thaliana were prepared by CRISPR/Cas9‐mediated genome editing to investigate the role of WHIRLY1 during early seedling development. The loss‐of‐function of WHIRLY1 in 5‐day‐old seedlings did not cause differences in the phenotype and the photosynthetic performance of the emerging cotyledons compared with the wild type. Nevertheless, comparative RNA sequencing analysis revealed that the knockout of WHIRLY1 affected the expression of a small but specific set of genes during this critical phase of development. About 110 genes were found to be significantly deregulated in the knockout mutant, wherein several genes involved in the early steps of aliphatic glucosinolate (GSL) biosynthesis were suppressed compared with wild‐type plants. The downregulation of these genes in WHIRLY1 knockout lines led to decreased GSL contents in seedlings and in seeds. Since GSL catabolism mediated by myrosinases was not altered during seed‐to‐seedling transition, the results suggest that AtWHIRLY1 plays a major role in modulation of aliphatic GSL biosynthesis during early seedling development. In addition, phylogenetic analysis revealed a coincidence between the evolution of methionine‐derived aliphatic GSLs and the addition of a new WHIRLY in core families of the plant order Brassicales.

Protein engineering through directed evolution and (semi)rational design has become a powerful approach for optimizing and enhancing proteins with desired properties. The integration of artificial intelligence methods has further accelerated protein engineering process by enabling the development of predictive models based on datadriven strategies. However, the lack of interpretability and transparency in these models limits their trustworthiness and applicability in real-world scenarios. Explainable Artificial Intelligence addresses these challenges by providing insights into the decision-making processes of machine learning models, enhancing their reliability and interpretability. Explainable strategies has been successfully applied in various biotechnology fields, including drug discovery, genomics, and medicine, yet its application in protein engineering remains underexplored. The incorporation of explainable strategies in protein engineering holds significant potential, as it can guide protein design by revealing how predictive models function, benefiting approaches such as machine learning-assisted directed evolution. This perspective work explores the principles and methodologies of explainable artificial intelligence, highlighting its relevance in biotechnology and its potential to enhance protein design. Additionally, three theoretical pipelines integrating predictive models with explainable strategies are proposed, focusing on their advantages, disadvantages, and technical requirements. Finally, the remaining challenges of explainable artificial intelligence in protein engineering and future directions for its development as a support tool for traditional protein engineering methodologies are discussed.

Results of scientific work in chemistry can usually be obtained in the form of materials and data. A big step towards transparency and reproducibility of the scientific work can be gained if scientists publish their data in research data repositories in a FAIR manner. Nevertheless, in order to make chemistry a sustainable discipline, obtaining FAIR data is insufficient and a comprehensive concept that includes preservation of materials is needed. In order to offer a comprehensive infrastructure to find and access data and materials that were generated in chemistry projects, we combined the infrastructure Chemotion repository with an archive for chemical compounds. Samples play a key role in this concept: we describe how FAIR metadata of a virtual sample representation can be used to refer to a physically available sample in a materials’ archive and to link it with the FAIR research data gained using the said sample. We further describe the measures to make the physically available samples not only FAIR through their metadata but also findable, accessible and reusable.

Hornstedtia scyphifera (J.Koenig) Steud. represents a lesser-known member of the ginger family (Zingiberaceae) that is used in Malaysia as spice and traditional medicine. The phytochemical investigation of leaves from this species utilizing diverse analytical methods has provided comprehensive insights into its chemical profile for the first time. Headspace gas chromatography-mass spectrometry (HS-GCMS) and GCMS analyses of essential oil and nonpolar extracts verified α-pinene, camphene, p-cymene, and camphor as main volatile compounds. Metabolite profiling of the crude extract by ultra-high-performance-liquid chromatography-high resolution mass spectrometry (UHPLC-HRMS) unveiled terpenoids, flavonoids and other phenolics as major compound classes. Isolation and follow-up structure elucidation, involving 1D and 2D NMR, HRMS, UV and CD analysis, yielded two new sesquiterpenoids, (1R,5S,6S,7R,10R)-mustak-14-oic acid (1) and (1R,6S,7S,10R)-6-hydroxy-anhuienosol (2), along with 24 known compounds (seven terpenoids, seven flavonoids, ten phenolics), 21 of these never reported for H. scyphifera. Additionally, the crude extract and fractions from the purification process were screened for antibacterial and antifungal activity. This is supplemented by an extensive literature research for described bioactivities of all isolated compounds. Our results support and explain previously detected antimicrobial, antifungal and neuroprotective effects of H. scyphifera extracts and provide evidence for its potential pharmacological importance.

Hyaloperonospora arabidopsidis (Hpa) is an oomycete pathogen that causes downy mildew disease on Arabidopsis. This obligate biotroph manipulates the homeostasis of its host plant by secreting numerous effector proteins, among which are the RxLR effectors. Identifying the host targets of effectors and understanding how their manipulation facilitates colonization of plants are key to improve plant resistance to pathogens. Here we characterize the interaction between the RxLR effector HaRxL106 and BIM1, an Arabidopsis transcription factor (TF) involved in Brassinosteroid (BR) signaling. We report that HaRxL106 interacts with BIM1 in vitro and in planta. BIM1 is required by the effector to increase the host plant susceptibility to (hemi)biotrophic pathogens, and thus can be regarded as a susceptibility factor. Mechanistically, HaRxL106 requires BIM1 to induce the transcriptional activation of BR‐responsive genes and cause alterations in plant growth patterns that phenocopy the shade avoidance syndrome. Our results support previous observations of antagonistic interactions between activation of BR signaling and suppression of plant immune responses and reveal that BIM1, a new player in this crosstalk, is manipulated by the pathogenic effector HaRxL106.

Modular cloning systems that rely on type IIS enzymes for DNA assembly have many advantages for construct engineering for biological research and synthetic biology. These systems are simple to use, efficient, and allow users to assemble multigene constructs by performing a series of one-pot assembly steps, starting from libraries of cloned and sequenced parts. The efficiency of these systems also facilitates the generation of libraries of construct variants. We describe here a protocol for assembly of multigene constructs using the modular cloning system MoClo. Making constructs using the MoClo system requires to first define the structure of the final construct to identify all basic parts and vectors required for the construction strategy. The assembly strategy is then defined following a set of standard rules. Multigene constructs are then assembled using a series of one-pot assembly steps with the set of identified parts and vectors.

Efficient DNA assembly methods are an essential prerequisite in the field of synthetic biology. Modular cloning systems, which rely on Golden Gate cloning for DNA assembly, are designed to facilitate assembly of multigene constructs from libraries of standard parts through a series of streamlined one-pot assembly reactions. Standard parts consist of the DNA sequence of a genetic element of interest such as a promoter, coding sequence, or terminator, cloned in a plasmid vector. Standard parts for the modular cloning system MoClo, also called level 0 modules, must be flanked by two BsaI restriction sites in opposite orientations and should not contain internal sequences for two type IIS restriction sites, BsaI and BpiI, and optionally for a third type IIS enzyme, BsmBI. We provide here a detailed protocol for cloning of level 0 modules. This protocol requires the following steps: (1) defining the type of part that needs to be cloned, (2) designing primers for amplification, (3) performing polymerase chain reaction (PCR) amplification, (4) cloning of the fragments using Golden Gate cloning, and finally (5) sequencing of the part. For large standard parts, it is preferable to first clone sub-parts as intermediate level-1 constructs. These sub-parts are sequenced individually and are then further assembled to make the final level 0 module.

An oligopeptide of 13 amino acids (Pep-13) identified within a 42 kDa glycoprotein elicitor from P. megasperma was shown to be necessary and sufficient to stimulate a complex defense response in parsley cells comprising H+/Ca2+ influxes, K+/Cl− effluxes, an oxidative burst, defense-related gene activation, and phytoalexin formation. Binding of radiolabeled Pep-13 to parsley microsomes and protoplasts was specific, reversible, and saturable. Identical structural features of Pep-13 were found to be responsible for specific binding and initiation of all plant responses analyzed. The high affinity binding site recognizing the peptide ligand (KD = 2.4 nM) may therefore represent a novel class of receptors in plants, and the rapidly induced ion fluxes may constitute elements of the signal transduction cascade triggering pathogen defense in plants.

The plant growth substance jasmonic acid and its methyl ester (JA‐Me) induce a set of proteins (jasmonate‐induced proteins, JIPs) when applied to leaf segments of barley (Hordeum vulgare L. cv. Salome). Most of these JIPs could be localized within different cell compartments by using a combination of biochemical and histochemical methods. Isolation and purification of various cell organelles of barley mesophyll cells, the separation of their proteins by one‐dimensional polyacrylamide gel electrophoresis and the identification of the major abundant JIPs by Western blot analysis, as well as the immuno‐gold labelling of JIPs in ultrathin sections were performed to localize JIPs intracellularly. JIP‐23 was found to be in vacuoles, peroxisomes, and in the granular parts of the nucleus as well as within the cytoplasm; JIP‐37 was detected in vacuoles and in the nucleoplasm; JIP‐66 is a cytosolic protein. Some less abundant JIPs were also localized within different cell compartments: JIP‐100 was found within the stromal fraction of chloroplasts; JIP‐70 is present in the peroxisome and the nucleus; JIP‐50 and JIP‐6 accumulate in vacuoles. The location of JIP‐66 and JIP‐6 confirms their possible physiological role deduced from molecular analysis of their cDNA.